STEP 7 (See Diagram 7 & Cable Loop Diagram)
A.) Attach the 131” Lower Cable (#36) to the opening on the bottom of the Leg Developer (#9).
B.) Attach a Pulley to the opening. Secure it with one M10 x 2 ½” Allen Bolt (#74), two Ø 7/8” x 5/8” Pulley Bushings (#43), and one M10 Aircraft Nut (#82).
C.) Draw the Cable underneath the Pulley to the opening in between the two Seat Support Frames (#10).
D.) Attach a Pulley to the opening. Secure it with one M10 x 2 ¾” Allen Bolt (#75), two Ø ¾” Washers (#80) and one M10 Aircraft Nut (#82). Insert a M10 x 2 ½” Allen Bolts (#74) through the hole on the two Seat Support Frames under the Pulley. Secure the Bolt with two Ø ¾” Washers (#80) and one M10 Aircraft Nut (#82).
E.) Draw the Cable underneath the Pulley along the Main Base Frame to the opening on the bottom of the Vertical Frame (#4). Repeat Procedure B above to install another Pulley.
F.) Pull the Cable upward to the Crossed Double Floating Pulley Bracket (#17) previously installed in
| (#72), two Ø ¾” Washers (#80) and one M10 Aircraft Nut (#82). |
G.) Draw the Cable over the Pulley then downward to the opening on the bottom of | |
| Vertical Support Frame (#3). Repeat Procedure B to install another Pulley. |
H.) | Pull the Cable around the Pulley then upward to the Double Floating Pulley Bracket |
| (#29) previously installed in |
| Bolt (#72), two Ø ¾” Washers (#80) and one M10 Aircraft Nut (#82). |
I.) | Draw the Cable around the Pulley then pull downward to the bracket on the back of |
| the Vertical Support Frame. Secure the Cable to the bracket with one M10 x 1” Allen |
| Bolt (#71), two Ø ¾” Washers (#80), and one M10 Aircraft Nut (#82). |
J.) | Adjust the tension of the Cable by adjusting the Pulley position on the Double |
| Floating Pulley Bracket (#29). If the cables are too loose, move the Pulley up one |
| hole. If the cables are too tight, move the Pulley down one hole. |
K.) | For best performance of the machine, adjust the Cables so the Selector Stem (Top |
| Plate) on the weight stack is ¼” above the first plate. To select the weight, push |
| down on the Selector Stem to close the gap then insert the selector pin. This will |
| remove the slack in the cable system so the range of motion is smooth and tight. |
L.) | Connect the Shiver Bar (#20) to a Chain (#37) with a |
| Chain to the Lower Cable with another |
19