STEP 2 (See Diagram 2)
A.) Attach the Seat Support (#15) to the Vertical Beam (#4). Secure it with one Bracket (#26), two 3/8” x 3 7/8” Carriage Bolts (#68), ∅ 3/8” Washers (#77), and 3/8” Aircraft Nuts (#74).
B.) Attach the Seat post (#14) to the Seat Support (#15). Secure it with one Bracket (#26), two 3/8” x 3” Carriage Bolts (#69), ∅ 3/8” Washers (#77), and 3/8” Aircraft Nuts (#74).
C.) Secure the bottom of the Seat Post (#14) to the Front Base (#3) with one 3/8” x 4 ½” Carriage Bolt (#67), ∅ 3/8” Washer (#77) and 3/8” Aircraft Nut (#74).
D.) Insert the Seat Incline Adjustment (#16) into the hole on top of the Seat Post (#14). Secure it with a quick Release Lock Pin (#45).
E.) Place the Seat Pad (#20) onto the Seat Incline Adjustment (#16). Secure it with two M8 x 1 ½” Allen Bolts (#65) and ∅ ¼” Washers (#76).
F.) Attach a Square Rubber Bumper (#29) onto the front opening on the Seat Support (#15). Secure it with one M10 x 1” Philips Screw (#70).
G.)Attach the Leg Developer (#17) to the Seat Support (#15). Secure it with one 3/8” x 3” Allen Bolt (#59), two ∅ 3/8” Washers (#77), and one 3/8” Aircraft Nut (#74).
H.) Insert the Foam Roll Tubes (#27) halfway through the hole on the Seat Incline Adjustment (#16) and Leg Developer (#17). Push four Foam Rolls (#43) onto the Tubes.
10