To control a DVD player:

Program the remote control to recognize the brand of your DVD player (see “Programming the remote control to operate your other devices” below.) The buttons shown at right will then control the DVD player.

Press “DVD” first.

Power

Input (TV)

Recall

Mute (TV)

Number

buttons

Volume +/- (TV)

DVD

Pic Size (TV)

DVD MENU

▲▼ ▼▼

ENTER DVD controls

DVD Skip/Search

/

TOP Menu

DVD Clear

Safeguards

Important

ToshibaWelcome to

Programming the remote control to operate your other devices

This remote control is pre-programmed to operate Toshiba satellite receivers, VCRs and DVD players. To control cable TV converters/ satellite receivers, VCRs and DVD players other than Toshiba models, you must follow the steps below to program your remote control.

1.Refer to the code tables (on pages 18 and 19) to find the corresponding code for your brand.

If more than one code is listed, try each one separately until you find the one that works.

2.If you are programming the remote control to operate your:

Cable TV converter/satellite receiver: Press “CBL/SAT.”

VCR: Press “VCR.”

DVD player: Press “DVD.”

3.While holding down RECALL, press the Channel Number buttons to enter the three-digit code for your cable TV converter/satellite receiver, VCR or DVD player brand.

4.Point the remote control at the cable TV converter/satellite receiver, VCR or DVD player, and press POWER to test the code.

If the cable TV converter/satellite receiver, VCR or DVD player responds, you entered the correct code.

If the cable TV converter/satellite receiver, VCR or DVD player does not respond, repeat steps 1–4 using another code.

5.Press “TV” to control the TV.

For future reference, write down the codes you used:

Cable TV converter/satellite receiver code _____________________

VCR code ______________________________________________

DVD player code _________________________________________

17

Recall

Channel

Numbers

TV

VCR

DVD

CBL/SAT

Notes:

When shipped from the factory, the remote control is set to operate your TV.

If you do not enter the code within 10 seconds from step 1 or if you enter a code not listed below, this operation is canceled.

Each time you replace the batteries, you must reprogram the remote control.

Some newer VCRs are capable of working on either of two remote codes. These VCRs have a switch labeled “VCR1/VCR2.”

If your VCR has this kind of switch and does not respond to any of the codes for your VCR, set the switch to the other position (VCR1 or VCR2) and reprogram the remote control.

yourConnecting TV

Remote ControlUsing the

your TVSetting up

FeaturesUsing the TV’s

Appendix

J3S40121A(E)_P16-23

17

18/01/2005, 9:49 AM

Page 17
Image 17
Toshiba 30HF85, 26HF85 appendix Programming the remote control to operate your other devices, To control a DVD player