See Diagram 12 & Cable Loop Diagram

STEP 12 (See Diagram 12 & Cable Loop Diagram)

A.) Attach one end of the 276” Leg Press Cable (#44) to the open bracket underneath the Left Seat Support (#15). Secure it with one M10 x 1” Allen Bolt (#81), two Ø ¾” Washers (#94), and one M10 Aircraft Nut (#97).

B.) Attach a Pulley to the top opening on the Leg Press Frame (#16). Secure it with one M10 x 2 3/8” Allen Bolt (#84), two Pulley Bushings (#78), and one M10 Aircraft Nut (#97).

C.) Draw the Cable around the Pulley then back to the top opening on the Left Seat Support. Repeat Procedure B above to install a Pulley.

D.) Draw the Cable around the Pulley back to the lower opening on the Leg Press Frame (#16). Repeat Procedure B above to install a Pulley.

E.) Draw the Cable around the Pulley along the Left Base Frame (#14) through the opening on the bottom of Left Vertical Beam (#17) to the first open bracket on the Left Base Frame.

F.) Install a Pulley and secure it with one M10 x 1 ¾” Allen Bolt (#82), one 2 7/8” L- shaped Cable Retainer (#33), two Ø ¾” Washers (#94), and one M10 Aircraft Nut (#97).

G.) Draw the Cable underneath the Pulley then upward to the Angled Double Floating

	Pulley Bracket (#27) previously installed in Step-8. Install a Pulley to the Bracket.
H.)	Draw the Cable around the Pulley then downward to the second open bracket on
	the Left Base Frame. Install a Pulley with an U-shaped Cable Retainer (#35).
I.)	Draw the Cable upward to the Flat Double Floating Pulley Brackets (#36) previously
	installed in Step-9. Install another Pulley.
J.)	Draw the Cable around the Pulley then downward to the open bracket on the rear
	of Left Base Frame. Install a Pulley with a 2 7/8” L-shaped Cable Retainer (#33).
K.)	Draw the Cable underneath the Pulley across the corner to the open bracket on the
	Right Base Frame (#1). Repeat Procedure J above to install a Pulley.
L.)	Draw the Cable underneath the Pulley then upward to the Flat Double Floating

Pulley Bracket (#36) previously installed in Step-10. Install another Pulley.

M.) Draw the Cable around the Pulley then downward to the open bracket on the Right Base Frame (#1). Secure the end of the Cable with one M10 x 1” Allen Bolt (#81), two Ø ¾” Washers (#94), and one M10 Aircraft Nut (#97).

N.) Check the tension of the cable loop system. If the cables are too loose, shorten the Short Chain previously installed in Step 11 G.