JVC MX-K50, SP-MXK50 manual Connecting Speakers, Release the finger from the clamp, AM antenna

English

AM antenna

1		2, 3
		Vinyl-covered wire
ANTENNA		(not supplied)
FM [75	]	AM
		AM loop antenna
		(supplied)

1Press and hold the clamp of the AM terminal on the rear of the unit.

2Insert the end of the AM loop antenna cord into the terminal.

•If the AM loop antenna wire is covered

with vinyl, remove the vinyl by twisting it as shown in the diagram.

3Release the finger from the clamp.

4Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM terminal and extend it horizontally. (The AM loop antenna must remain connected.)

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

Connecting Speakers

1	2, 3
	Red
	SPEAKER
	[6-16 ]
Speaker	Speaker
cord	cord
(red/black)	(red/black)
	Black
From right	From left
speaker’s	speaker’s
terminals	terminals

1Press and hold the clamp of the speaker terminal on the rear of the unit.

2Insert the end of the speaker cord into the

terminal.

Match the polarity (colors): Red (+) to red (+) and black

(–) to black (–).

• If the wire is covered with vinyl, remove the vinyl by twisting it as shown in the

diagram.

3Release the finger from the clamp.

IMPORTANT:

•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

•DO NOT connect more than one speaker to one speaker terminal.

– 7 –