JVC MX-J50 manual Using Recording Timer

6 When selecting “– CD – – –”

1)Press 4or ¢ to select the disc number, then press SET.

2)Press 4or ¢ to set the track number, then press SET.

The unit enters volume setting mode.

When selecting “TUNER FM” or “TUNER AM”

Press 4 or ¢ to select the preset station number, then press SET.

The unit enters volume setting mode.

PRESET

SEA CONTROL

SET

PRESET

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically.

How Recording Timer actually works

The unit automatically turns on, tunes into the specified station, sets the volume level to “0,” and starts recording

when the on-time comes (the indicator flashes just before the on-time, and continues flashing while the timer is operating). Then, when the off-time comes (“OFF” appears just before the off-time), the unit automatically turns off (stands by).

7 Press 4or ¢to set the volume level.

• You can select the volume level from

among four levels. If you select “ VOL – – –,” the volume is set to the last level when the unit has been turned off.

DAILY

8 Press SET to complete the Daily	SEA CONTROL
	SET
Timer setting.

The DAILY indicator stops flashing and remains lit. The settings you have done are shown on the display in sequence.

STANDBY

9 Press to turn off the unit (on standby) if you have set the Daily Timer with the unit turned on.

To turn on or off Daily Timer after its setting is done

1 Press TIMER/CLOCK repeatedly until	/CLOCK
	TIMER
“DAILY” appears on the display.

2To turn off the Daily Timer, press CANCEL.

The DAILY indicator goes off from the display. DEMO

The Daily Timer is canceled, but the setting for	CANCEL
the Daily Timer remains in memory.
To turn on the Daily Timer, press SET.	SEA CONTROL
The DAILY indicator lights up on the display.
	SET
The settings you have done are shown on the
display in sequence for your confirmation.

If the unit is turned on when the timer-on time comes

Daily Timer does not work.

The timer setting remains in memory until you change it.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•If you have made a mistake while setting the timer, press CANCEL. (However, this does not always work. If CANCEL does not work, press TIMER/CLOCK repeatedly and start from step 1 again.)

On the unit ONLY:

1 Put a recordable cassette into deck B.

2 Press TIMER/CLOCK until “REC”

TIMER

appears on the display. /CLOCK

The REC indicator also starts flashing on the display.

REC

•Each time you press the button, the timer setting modes change as follows:

DAILY ON TIME REC

Canceled	Clock	ON TIME
	setting

	(See page 9.)
3 Press TIMER/CLOCK again.		TIMER
“ON TIME” appears for 2 seconds, then the		/CLOCK
unit enters on-time setting mode.
	REC

REC

– 21 –