JVC MX-J50 manual Connecting Speakers, Release the finger from the clamp, AM antenna

Page 10

AM antenna

1 2 3

Connecting Speakers

You can connect a pair of front speakers, and one subwoofer.

To connect front speakers

ANTENNA

GND

AM LOOP

AM EXT

FM 75

COAXIAL

Vinyl-covered wire (not supplied)

1		2, 3
		Red
Speaker	SPEAKERS		Speaker
	RIGHT	LEFT	Speaker
			cord
cord			cord
cord
	Black

AM loop antenna (supplied)

1Connect the AM loop antenna to the AM LOOP terminals as illustrated.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

Right	Left
speaker	speaker

1Press and hold the clamp of the speaker terminal on the rear of the unit.

2Insert the end of the speaker cord into the

terminal.

Match the polarity of the speaker terminals: Red (+) to red (+) and black (–) to black (–).

3Release the finger from the clamp.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

– 7 –

Image 10

Contents MX-J50 Class Laser Product CA-MXJ50 Introduction PrecautionsAbout This Manual Contents Powered Rolling Panel Location of the Buttons and ControlsFront Panel Powered Rolling PanelDisplay Window Remote Control Remote ControlGetting Started Unpacking Connecting AntennasPutting the Batteries into the Remote Control FM antennaAM antenna Connecting SpeakersRelease the finger from the clamp To connect front speakersTo connect a subwoofer Connecting Other EquipmentPress and hold Demo for more than Seconds.DEMO To connect an analog componentTurning On the Power and Selecting the Sources Setting the ClockCommon Operations Reinforcing the Bass Sound Adjusting the VolumeTo turn down the volume level temporarily Selecting the Sound ModesTo use your own sound mode Creating Your Own Sound Mode Manual ModeAdjust the SEA pattern On the unit only Press and hold SEA Control untilPresetting Stations Tuning in a StationTuning in a Preset Station Listening to FM and AM BroadcastsPlaying Back the Entire Discs Continuous Play Playing Back CDsLoading CDs Basic CD OperationsProgram Play Prohibiting Disc Ejection Tray Lock Playing at Random Random PlayRepeating Tracks or CDs Repeat Play Prepare CDsPlaying Back a Tape Playing Back TapesLocating the beginning of a Song Music Scan Recording Tapes on Deck B On the remote controlRecording Start recording. On the unit Press REC START/STOPDubbing Tapes CD Direct RecordingPress SET To cancel Auto Edit RecordingAuto Edit Recording To change the tape length manuallyUsing the Timers Using Daily TimerUsing Recording Timer Using Sleep Timer Timer PriorityHandling discs MaintenanceCassette decks Troubleshooting 0599MWMMDWJEM