Using the Tuner
●Auto Tuning
If you press and hold the 4 or ¢ (
or 
) but- ton for one second or more, the frequency changes down, or up, automatically until a station is found.
OR
●Preset Tuning using the Remote Control (Possible only after presetting stations)
Select the desired preset number using the Number buttons on the Remote Control. (For the preset num- ber more than 10, press the +10 button then the Num- ber button.) After 1 second the display will show the preset number’s band and frequency.
Example:
Press the +10 button then the 2 button continuously. The preset number 12 “P12” appears.
+10 
2
(After 1 second)
●Preset Tuning using the Unit
Press the PRESET+ button to select the desired preset number.
Its band and frequency are displayed.
3 Press the SET button.
“SET” will blink for 5 seconds.
Within 5 seconds, proceed to the next step.
When the display returns to the one set in step 2 after 5 seconds, press the SET button again.
4 Press the > or < button within 5 seconds to select the preset number.
> or < button: | Increase or decrease the preset |
| number by 1. |
| Pressing and holding the button |
| will rapidly increase or decrease |
| the preset number. |
5 Press the SET button within 5 seconds.
“STORED” appears and after 2 seconds, the display re- turns to the broadcast frequency display.
6 Repeat above steps 1 to 5 for each sta- tion you want to store in memory with a preset number.
To change the preset stations, repeat the same
steps as above.
English
|
|
| CAUTION: |
|
|
| • Even if the system is unplugged or if the |
|
| ||
• In AM broadcast, reception sensitivity will be changed by |
| power failure occurs, the preset stations | |
turning the AM loop antenna. Turn the AM loop antenna |
| will be stored for about 24 hours. However, | |
for best reception. |
| in case the preset stations are erased, you | |
|
|
| will need to preset the stations again. |
|
|
| |
Presetting Stations
(Using the Remote Control)
You can preset up to 30 FM stations and up to 15 AM sta- tions.
•Preset numbers may have been set to factory test fre- quencies prior to shipment. This is not a malfunction. You can preset the stations you want into memory by following one of the presetting methods below.
Manual Presetting
SET | STORED |
FM/AM |
|
SET | SET |
| or | |
When changing | FM = 30, AM = 15 | |
the Band | ||
|
1 Select a band by pressing the FM/AM button.
2 Press the 4 or ¢ (
or 
) button to tune in a station.
To Change the FM Reception Mode
(Using the Remote Control)
When you are tuned into an FM stereo broadcast, the
“STEREO” indicator lights up and you can hear stereo ef- fects.
If an FM stereo broadcast is hard to receive or noisy, you can select Monaural mode. Reception improves, but you lose stereo effect.
Press the FM MODE button on the Remote Control so that the “MONO” indicator lights up on the dis- play.
FM MODE
MONO
To restore the stereo effect, press the FM MODE but- ton on the Remote Control so that the “MONO” indicator goes off.
18