Precor none manual 5Reinstall the Bracket Cover

Cardio Theater Integrated Bracket Assembly Instructions

5Reinstall the Bracket Cover

1.Prepare the fasteners for reinstalling the bracket cover.

Push the washers and bearings toward the bolt heads so there is room for the bracket cover to slide in flush against the pivot tube.

Important: Keep the bracket cover flanges flush with the pivot tube.The washers and bearings need to remain on the outside of the bracket flanges.

2.Replace the bracket cover.

Hold the bracket cover above the pivot tube. Apply pressure to the top of the bracket cover while you slide it into position.

3.Tighten the top two screws on the back of the LCD Screen.

Use a Phillips-head screwdriver to fully tighten the top two screws on the back of the LCD Screen. Access holes have been drilled through the bracket cover.

4.Secure the bracket cover.

Using a torque wrench and a ⁷⁄₃₂-inch hex key, retighten the two pivot tube fasteners to 120 in-lbs.

1		2	Top of the bracket
			cover
	Bracket
	cover
	Pivot tube
3
	Bracket cover	4
			Pivot tube

Reinstall the Bracket Cover

page 12