Cardio Theater Integrated Bracket Assembly Instructions
3Install the Bracket
Assembly
Important: Assemble the fasteners throughout these instructions as detailed in each step. When in doubt, use the illustrations for help. Do not fully tighten fasteners until instructed to do so.
1.Remove the bracket cover.
Loosen the bolts on the pivot tube using a
2.Feed the cables through the center tube of the bracket assembly.
Locate the coaxial/power cable and controller cable provided with the LCD Screen. Feed the end of the coaxial/power cable with its two connectors and the controller cable through the top hole in the center tube of the bracket assembly. Leave about 3 feet of the cables hanging out of the hole at the top of the bracket.
Note: The 3 feet (1 meter) of cables hanging out of the upper hole consist of the controller cable and the end of the coaxial/power cable with coaxial and power connectors. These cables will be attached to the back of the LCD Screen.
1 |
| |
Bracket |
| |
assembly | Bracket | |
| ||
Pivot | cover | |
tube |
| |
Bracket | Bracket | |
assembly | ||
cover | ||
| ||
2 |
| |
Controller cable |
| |
| Center | |
| tube | |
Coaxial/power |
| |
cable | assembly | |
Bracket |
Install the Bracket Assembly
page 6