Specialized FSR 130 manual Fork Setup Information

Page 7

FORK SETUP

INFORMATION

!

WARNING: The Stumpjumper 130 frame is compatible ONLY with single crown forks that have travel of 5.1” (130mm) or less.

Use of different styled forks or forks with longer travel may result in catastrophic failure of the frame which may result in serious personal injury or death.

SEAT POST SETUP

SEATPOST MINIMUM INSERTION: To prevent damage to the frame, it’s important to have a minimum amount of seatpost in the seat tube.

Small / Medium frame: 70mm insertion

Large / X-Large frame: 100mm insertion

If you cannot see the seatpost tube through this hole, your seatpost is too far extended. If a greater saddle height is required, replace the seatpost with a longer one.

SM/MD:70mm

LG/XL:100mm

7

Image 7
Contents Carbon Stumpjumper FSR Page Table of Contents Introduction Introduction Introduction Fork Setup Information Mudflap Fender Works Carbon 130 Frame Features Works Carbon 130 Frame Geometry Works Carbon 130 Frame Geometry SJ 130 Rear Air Shock Setup Rear Shock SetupDerailleur Guard Installation Works Carbon 130 Instructions Bottom Bracket Page Bearing Kit Parts Bolt Kit Parts SBC Limited Warranty Useful Product Life Cycle