JVC rx-8010vbk manual Connecting the Speakers, AM Antenna Connections, Basic connecting procedure

AM Antenna Connections

Snap the tabs on the loop into the

ANTENNA	slots of the base to assemble the
FM 75
	AM loop.
COAXIAL

AM	AM Loop Antenna
LOOP

AM

EXT

123

Outdoor single vinyl-covered wire (not supplied)

Turn the loop until you have the best reception.

Notes:

• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.

•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.

•If reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal. (Keep the AM loop antenna connected.)

Connecting the Speakers

You can connect the following speakers:

•Two pairs of front speakers to produce normal stereo sound.

•One pair of rear speakers to enjoy the surround effect.

•One center speaker to produce more effective surround effect (to emphasize human voices).

•One subwoofer to enhance the bass.

IMPORTANT:

After connecting the speakers listed above, set the speaker setting information properly to obtain the best possible Surround and DSP effect. For details, see page 17.

For each speaker (except for a subwoofer), connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers. For connecting a subwoofer, see page 5.

CAUTION:

Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals.

Basic connecting procedure

1 2 3 4

1Cut, twist and remove the insulation at the end of each speaker signal cable (not supplied).

2Turn the knob counterclockwise.

3Insert the speaker signal cable.

4Turn the knob clockwise.

Connecting the front speakers

You can connect two pairs of front speakers (one pair to the FRONT SPEAKERS 1 terminals, and another pair to the FRONT SPEAKERS 2 terminals).

Right speaker FRONT SPEAKERS 1 Left speaker

21

+

CAUTION :

SPEAKER IMPEDANCE

RIGHT LEFT RIGHT LEFT 4 6 LOW

8 16 HIGH

–

SPEAKER LOAD SELECTOR

FRONT SPEAKERS

Right speaker FRONT SPEAKERS 2 Left speaker

IMPORTANT:

To obtain the best possible output power from the receiver, and to prevent the receiver from being overheated, the receiver has the SPEAKER LOAD SELECTOR which has to be set as follows:

•Set it to “HIGH” when the impedance of the front speakers connected is within the range of 8 Ω to 16 Ω.

•Set it to “LOW” when the impedance of the front speakers connected is within the range of 4 Ω to 6 Ω.

4