Assembly
18 | Cap Nut |
| |
| Front Axle |
Handlebar
• Slide the front axle through the handlebar.
20
Headlight Lens
L
“L”
•Align the “L” on the left headlight lens with the “L” in the left headlight on the fairing.
•Insert the tabs on the headlight lens into the slots in the fairing.
•Press firmly to snap the headlight lens into the fairing.
•Repeat this procedure to assemble the right headlight lens (marked “R”) to the fairing.
Note: If the front axle will not slide through the handlebar, the handlebar may be out of alignment. To
•Fit a cap nut on the end of the front axle.
•Support the front axle and tap the cap nut with a hammer to secure it on the end of the front axle.
19
1
1
•Position the vehicle upright.
•Apply headlight labels to the fairing as shown.
•Make sure the areas where the labels will be applied are clean and dry.
21
5
Gas Cap
•Snap the gas cap into the vehicle body.
•Apply the fuel label to the gas cap.
•Make sure the area where the label will be applied is clean and dry.
22 | Seat |
| |
Tabs |
|
•Insert the tabs on the front of the seat into the vehicle body.
•Lower the seat. Do not fasten the seat until you have installed your charged battery. (See Battery Installation instructions on page 16.)
13