|
| Battery Charging |
1 | 25 Amp Fuse | 3 |
| ||
GOOD FUSE | "BLOWN" FUSE |
|
•If you are charging the battery for the first time, insert a 25 amp fuse into the battery.
Note: The top of the fuse will not be flush with the top of the battery when properly installed.
•If you are recharging your battery, make sure the 25 amp fuse already installed in the battery is in good condition. Remove the fuse from the battery and look at it to make sure it is not blown. Replace a blown fuse with a new Power Wheels® 25 amp fuse.
2 ChargerConnector
Battery
Connector
•Squeeze the connector tabs on the charger connector and plug it into the battery connector.
IMPORTANT NOTE! If you are recharging your battery, you will first need to disconnect the battery connector from the motor harness connector under the seat.
• Plug the charger into a standard wall outlet.
Note: If power flow to the wall outlet is controlled by a switch, make sure the switch is “ON”.
•Before
Note: The battery must be upright while charging.
•Recharge the battery for at least 14 hours after each use of your vehicle. Do not charge the battery longer than 30 hours.
•Once the battery is charged, disconnect the charger connector from the battery connector. Unplug the charger from the wall outlet. The battery is now ready to be installed in your vehicle. Please see the Battery Installation section on page 16 for detailed instructions on installing your battery. If your battery is already installed in your vehicle, simply
8