Jumpking OR1213 manual Marking

1.Make sure you understand the information in the box at the top of this page before you begin assembling the trampoline.

Lay three Top Tubes (1), (2) and (3) on the ground as shown. Make sure there is a T-connector(4) on Top Tube (1, A marking with bigger end), Socket(7) on the Top Tube(2, B marking with bigger end) and T-connector(4) on the Top Tube(3, c marking with bigger end).

Insert Top Tube(1, A marking with small end) into Socket(7). Then insert Top Tube(1, 2) into Top Tube(3, C marking with bigger end).

Insert a center leg(6) into the leg(5). Tighten a self-taping screw(12) into small hole in the leg(5). Insert the leg (5) into the T-connector(4).

You have now assembled one leg section. Repeat this step to assemble three more leg sections.

2.Note: This step requires two persons. During this step, you will connect the four leg sec- tions.

Hold two leg sections in the positions shown.

Insert the small end of Top Tube (3, C marking) into the T-connector(4) on another Top Tube (1, A marking).

Repeat this step until all four leg sections are connected.

15

	1
				Center
		12		6			5
					12
		4		7	2, B marking
			1, A marking				3, C marking
	2	3		4		2
	2				1
1		4					3	1
4		3
								2
			2	1		4	3
		5
				6