10.Attach the other three Pole(16,17) in the same way. See inset drawing.
11.Lay out Top G3 Pole (18), joint each section Connector to a straight line as shown.
Assemble the remaining Top G3 Pole (18) in the same way.
Spread the Netting (20) on the trampoline bed, insert a Top G3 Pole (18) into the opening of Top Sleeve on the Netting (20). Insert the other Top G3 Pole (18) into the opposite opening of Top Sleeve on the Netting (20).
12.Joint each end of Top G3 Pole (18) by the clip of connector at each opening. The Top Sleeve of the Netting (20) become a round shape.
10
17
16
11
18
11.a
Opening
(18)
Netting(20)
Insert the pole into sleeve of the Netting(20)
12
Joint the end of each pole by Clip of Connector
Start:
Finish:
Top Sleeve
Door of Netting
19