Huffy M732211 manual Dimple Hole

Page 11

3. Bounce top and middle pole assembly (4 and 5) onto bottom pole section (6) using a wood scrap as shown. Bounce until the top and middle pole assembly no longer moves toward the pole identification mark on the bottom pole.

IMPORTANT!

Align dimple of middle pole section (5) into trough of bottom pole section (6) as shown.

1-1/2"

Bottom pole

5"

ID

STICKER

CAUTION!

THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A 3-1/2" MINIMUM OVERLAP, LEAVING 1-1/2"

BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.

Bottom pole

DIMPLE

HOLE

4

5

RODS SHOWN ARE

FOR VISUAL

REPRESENTATION

OF ALIGNMENT

AND ARE NOT

SUPPLIED WITH THE HARDWARE

6

WOOD SCRAP

(NOT SUPPLIED)

11

05/06

ID# M732211

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Write Model Number From Box Here Before YOU Start Moving Product Registration Front View Parts List See Hardware Identifier Hardware Identifier Bolts & Pins Item #7 Item #44 Section a Assemble the Base Align dimple of top pole into trough of middle pole as shown Dimple Hole Do not Over Orientation of Struts Section B Attach the Backboard Elevator Tubes USE EYE Protection When Installing Springs 05/06 ID# M732211 ID# 05/06 ID# M732211 ID# M732211 05/06 Install Rim to Backboard 14.A
Top Page Image Contents