Huffy M5800152 manual FIG a

Page 8

IMPORTANT!

ONCE POLE SECTIONS ARE POUNDED TOGETHER - THEY CANNOT BE TAKEN APART

2. Align poles using alignment marks. First, pound top and middle poles together by bouncing them on a scrap piece of wood on the ground as shown in FIG A. until they no longer move toward pole identification stickers. THEN add bottom pole section and pound together in the same way.

TOP

CAUTION!

THE IDENTIFICATION STICKER IS LOCATED 3-3/4" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A 2-1/2" MINIMUM OVERLAP, LEAVING 1-1/4"

BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.

2

alignment mark

MIDDLE

FIG A.

scrap wood (Not Supplied)

IDENTIFICATION

STICKER

middle pole

3-1/2”

3

alignment mark

BOTTOM

IDENTIFICATION

 

STICKER

1-1/4"

 

 

middle pole

4

ID# M5800151

11/05

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Write Model Number From Box Here Height Adjustment Safety Instructions Front Back Parts List Parts Identifier Actual Size Section a Assemble the Poles FIG a Pole assembly clockwise as shown Repeat for other side Sawhorse or Support Table If Using Sand Feet 98 m Système portable Manuel de Lutilisateur Outils ET Matériel Requis Höheneinstellung Ajuste DE LA Altura Consignes DE Sécurité ¡ALTO! ¡NO regrese a la tienda Wichtig Liste DES Pièces Teileliste #11 #12 #14 #13 #15 #21 #22 Conjunto DEL Elevador Section Inférieure FIG. a Attachez lensemble du poteau au réservoir, comme Fissare al palo i montanti 21 e 22 del serbatoio ID# M5800151 11/05 Vorsicht Avertissement Warnung ¡ADVERTENCIA! Avvertenza
Top Page Image Contents