Huffy DC177 manual Pole Sections Should have a

Page 10

3.Align top holes of top pole to bottom holes of bottom pole. While maintaining alignment, bounce top and middle pole assembly (1 & 2) onto lower section (3) using a wood scrap as shown until they no longer move toward pole identification mark on bottom pole (3).

IMPORTANT!:

Holes in top (1) and bottom pole (3) sections MUST align to correctly position elevator system toward playing surface.

1

Taped Reference

Mark

2

NOTE:

 

POLE SECTIONS

 

SHOULD HAVE A

 

3-1/2" (9 CM) MINIMUM

3

OVERLAP.

 

RODS SHOWN ARE

FOR VISUAL

REPRESENTATION

OF ALIGNMENT

AND ARE NOT

SUPPLIED WITH THE HARDWARE

WOOD SCRAP

(NOT SUPPLIED)

P/N 211475

01/04

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Portable Basketball System U.S.1-800-558-5234 and Canada Safety Instructions Front Back Qty Description Hardware Identifier Bolts & Screws Height Adjustment Before YOU Start Section a Assemble the Poles LabelPole Sections Should have a Section B Assemble the Base AND/OR01/04 Do not Over Tighten 01/04 Section C Assemble the Elevator & Backboard Socket Wrenches and Sockets 9/16 3/401/04 FIG. a Keep Hardware Loose Until After is Completed 01/04 Tighten ALL Hardware from 8 After this Assembly is Completed 01/04 USE EYE Protection Section D Securing the System Section E Install Front Cover FIG.ASection F NET Installation Install clipsInsert net into bottom of clip as shown Height Adjustment Section G Apply Height and Moving LabelSection H Height Adjustment
Top Page Image Contents