Huffy NCS102 manual Section G Apply Height and Moving Label, Height Adjustment

Page 27

SECTION G: APPLY HEIGHT AND MOVING LABEL

1.Apply Height Adjustment and Moving Label (42) to front of pole, where it is clearly visible.

42

HEIGHT ADJUSTMENT

TO ADJUST BACKBOARD:

			1
1. While holding handle, remove pin.		3
2. Move elevator up or down to
desired height.		2
3. Replace pin full length to lock
system at desired height.
		2
MOVING SYSTEM
1.	Adjust basketball backboard
1	height to lowest position.
2. While holding pole, rotate
	basketball system forward
	until wheels engage with
	ground.
3. Move basketball system to
2	desired location.
2
4.	Carefully rotate basketball
3	system upright.
4
5. Reattach ground restraint and
	check system for stability.
		201252	2/99

27

03/04

P/N 21447702

Image 27

Contents Portable Basketball System 21447702 03/04 Safety Instructions Front Back Qty Description Hardware Identifier Bolts & Screws Height Adjustment Before YOU Start Label Section a Assemble the PolesPole Sections Should have a AND/OR Section B Assemble the BaseDo not Over Tighten 03/04 Install wheel assembly to base 8 using Socket Wrenches and Sockets 9/16 3/4 Section C Assemble the Elevator & Backboard21447702 03/04 FIG. a Face of Backboard 03/04 Tighten ALL Hardware from 8 After this Assembly is Completed 03/04 USE EYE Protection Section D Securing the System FIG.A Section E Install Front CoverInstall clips Section F NET InstallationInsert net into bottom of clip as shown Section G Apply Height and Moving Label Height AdjustmentSection H Height Adjustment Français Deutsch Español Arrière Warnung Consignes DE Sécurité Avis AUX Personnes Chargées DU Montage Liste DES Pièces Teileliste Lista DE Piezas Identification DES Pièces Boulons ET VIS Height Adjustment Remarque Hinweis Nota Remarque Hinweis Nota UND/ODER ET/OU Wichtig ¡IMPORTANTE Avertissement Warnung ¡ADVERTENCIA 03/04 2, 2 9/16 2 3/4 Page FIG. a ABB. a Face du panneau Korbwandvorderseite Cara del respaldo 21447702 03/04 Wichtig ¡IMPORTANTE 5020 03/04 Avertissement FIG.A ABB. a Installez les pinces Height Adjustment