Huffy NCS102 manual Wichtig ¡IMPORTANTE

Page 41

Assemblez le support du poteau (12) au

1. moyen d'un boulon (13) et d'un contre- écrou (14), de la façon illustrée.

Die Stangenhalterung (12) wie gezeigt mit Schraube (13) und Gegenmutter (14) zusammenbauen.

Monte el soporte del poste (12) usando el perno (13) y la contratuerca (14) como se muestra.

Fixez le poteau sur le socle au moyen de boulons ordinaires (15),

2. de rondelles (10) et d'écrous (11), de la façon illustrée. Il est recommandé de s'y prendre à deux pour cette manœuvre.

Den Stangenbaugruppe wie gezeigt mit Schlossschrauben (15), Unterlegscheiben (10) und Muttern (11) am Sockel befestigen. Dieses Schritt muss von zwei Personen ausgeführt werden.

Instale el conjunto del poste en la base usando pernos cabeza de carro (15), arandelas (10) y tuercas (11) como se muestra. Se recomienda que dos personas realicen este paso.

IMPORTANT!

WICHTIG!

¡IMPORTANTE!

NE SERREZ PAS TROP !

NICHT ZU FEST ANZIEHEN.

NO APRIETE EXCESIVAMENTE

15

14

13

12

IMPORTANT!:

LES COINS BISEAUTÉS DU SUPPORT DE POTEAU DOIVENT ÊTRE ORIENTÉS VERS L'ARRIÈRE DU SOCLE, DE LA FAÇON ILLUSTRÉE.

DIE ABGESCHRÄGTEN ECKEN DER STANGENHALTERUNG MÜSSEN WIE GEZEIGT ZUR RÜCKSEITE DES SOCKELS HIN WEISEN.

LAS ESQUINAS RECORTADAS DEL SOPORTE DEL POSTE NECESITAN ESTAR ORIENTADAS HACIA LA PARTE POSTERIOR DE LA BASE COMO SE MUESTRA.

10

11

AVERTISSEMENT !

WARNUNG!

¡ADVERTENCIA!

Il est obligatoire de s'y prendre à deux pour cette procédure. SUIVEZ CET AVERTISSEMENT SOUS PEINE D'ENCOURIR DES BLESSURES GRAVES ET/OU DES DÉGÂTS MATÉRIELS.

Dieses Schritt muss von zwei Personen ausgeführt werden. EIN MISSACHTEN DIESER WARNUNG KANN ZU SCHWEREN VERLETZUNGEN UND/ODER SACHSCHÄDEN FÜHREN.

Se requieren dos personas para realizar este procedimiento. SI NO SE OBSERVA ESTA ADVERTENCIA SE PODRÍA OCASIONAR UNA lesión GRAVE Y/O DAÑOS A LA PROPIEDAD.

41

03/04

P/N 21447702

Image 41
Contents Portable Basketball System 21447702 03/04 Safety Instructions Front Back Qty Description Hardware Identifier Bolts & Screws Height Adjustment Before YOU Start Label Section a Assemble the PolesPole Sections Should have a AND/OR Section B Assemble the BaseDo not Over Tighten 03/04 Install wheel assembly to base 8 using Socket Wrenches and Sockets 9/16 3/4 Section C Assemble the Elevator & Backboard21447702 03/04 FIG. a Face of Backboard 03/04 Tighten ALL Hardware from 8 After this Assembly is Completed 03/04 USE EYE Protection Section D Securing the System FIG.A Section E Install Front CoverInstall clips Section F NET InstallationInsert net into bottom of clip as shown Section G Apply Height and Moving Label Height AdjustmentSection H Height Adjustment Français Deutsch Español Arrière Warnung Consignes DE Sécurité Avis AUX Personnes Chargées DU Montage Liste DES Pièces Teileliste Lista DE Piezas Identification DES Pièces Boulons ET VIS Height Adjustment Remarque Hinweis Nota Remarque Hinweis Nota UND/ODER ET/OU Wichtig ¡IMPORTANTE Avertissement Warnung ¡ADVERTENCIA 03/04 2, 2 9/16 2 3/4 Page FIG. a ABB. a Face du panneau Korbwandvorderseite Cara del respaldo 21447702 03/04 Wichtig ¡IMPORTANTE 5020 03/04 Avertissement FIG.A ABB. a Installez les pinces Height Adjustment