Impex MSS-1280 manual See Diagram 5 & Cable Loop Diagram

Page 14

STEP 5 (See Diagram 5 & Cable Loop Diagram)

A.) Attach the 62” Lower Cable (#26) to the open bracket on the Cross Brace (#7). Attach a Pulley (#33) to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#52), two Ø ¾” Washers (#57), one L-shaped Cable Retainer (#24), and one M10 Aircraft Nut (#58).

B.) Draw the Cable underneath the Pulley then upward to the 170” Upper Cable (#25) installed in Step-4.

C.) Connect the Lower Cable to a Hook (#36). Connect the Hook to the 5-link Chain (#44). Secure the 5-link Chain to the end of Upper Cable with one M10 x 1” Allen Bolt (#51), two Ø ¾” Washers (#57, and one M10 Aircraft Nut (#58). Adjust the tension of the Cable system by moving the Hook position to the Chain. If the tension is too loose then move the hook up the chain. If the tension is too tight then move down the Hook.

D.) Connect the Shiver Bar (#21) to the ball stopper on Lower Cable with two Hooks (#36) and one 15-link Chain (#42).

13

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Deluxe Smith Machine Table of Contents Before YOU BeginImportant Safety Notice Page Smith Machine Hardware Pack Cage Machine Hardware Pack Smith Machine Assembly Instruction DiagramPage Diagram Pulley bracket on the Weight Sliding Frame faces upward Securely tighten all Nuts and Bolts installed in , ,Diagram Cable Loop Diagram See Diagram 4 & Cable Loop Diagram See Diagram 5 & Cable Loop Diagram See Diagram Smith Machine Exploded Diagram Smith Machine Part List ’tyBench Hardware Pack Bench Hardware Pack Bench Assembly Instruction Diagram Diagram Diagram Diagram Page Bench Parts List Impex INC Info@impex-fitness.com
Top Page Image Contents