Impex MSS-1600 manual Diagram

Page 12

A.) Attach the Seat Support (#9) to Vertical Frame (#3). Secure it with two M10 x 2 3/8” Carriage Bolts (#61), one 5 1/8” Curved Bracket (#22), two Ø ¾” Washers (#74), and two M10 Aircraft Nuts (#76).

B.) Place the Seat (#26) onto the Seat Support. Secure it with two M8 x 2 1/8” Allen Bolts (#71) and Ø 5/8” Washers (#73).

C.) Attach the Arm Curl Pad (#27) to Arm Curl Stand (#77). Secure it with two M8 x 5/8” Allen Bolts (#72) and two Ø 5/8” Washers (#73). Insert the Arm Curl Stand into the opening on Seat Support. Use a Lock Knob (#44) to secure the Arm Curl Stand at desired height.

D.) Attach two ¾” Bushings (#40) to the Leg Developer (#10). Attach the Leg Developer to the bracket on the Seat Support. Secure it with one M10 x 3 1/8” Allen Bolt (#70), two Ø ¾” Washers (#74), and one M10 Aircraft Nut (#76). Do not over tighten the Bolt and Nut.

Make sure the Leg Developer is able to swivel on the Bolt (#70).

E.) Insert the 16 7/8” Long Foam Tube (#20) halfway through the hole on the Seat Support. Insert the 15 ¾” Foam Tube (#19) halfway through the hole on Leg Developer. Push four Foam Rolls (#38) onto the Tubes from both ends. Cover each end with a Foam Roll End Cap (#57).

DIAGRAM 3

11

STEP 4 (See Diagram 4)

Image 12
Contents Home GYM Toll-Free Customer Service Number Mon. Fri a.m. 5 p.m. PST Important Safety Notice PrecautionsPage Hardware Pack Hardware Pack Hardware Pack Hardware Pack Assembly Instruction DiagramSecurely tighten all Nuts and Bolts installed DIAGRAM-2 Diagram Page Diagram Cable Loop Diagram See Diagram 5 & Cable Loop Diagram Diagram See Diagram 6 & Cable Loop Diagram See Diagram 7 & Cable Loop Diagram Diagram See Diagram Exploded Diagram Parts List ’tyMSS-1600 Weight Resistance Chart Impex INC Info@impex-fitness.com