Impex MWM-1100 manual Securely tighten all Nuts and Bolts installed

STEP 2 (See Diagram 2)

A.) Slide 9 Weight Plates (#50) onto the Guide Rods (#5). Make sure the deep groove on the

Weight Plate are facing down and toward the back of the Machine.

B.) Align the holes on the Weight Plates. Insert a Selector Rod (#16) through the center hole. Use the L-shaped Pin (#57) to select the number of Weight Plates for exercise. Each Plate weighted approx. 10lbs. Please refer to the Weight Resistance Chart in page 21.

C.) Slide Selector Stem (#49) down the Guide Rods.

D.) Attach the holes on the Upper Frame (#4) onto the Guide Rods. Place the Upper Frame onto the Vertical Frame (#3).

E.) Secure the Upper Frame to the Guide Rods with two M10 x 1” Allen Bolts (#62) and two Ø ¾” Washers (#70).

F.) Secure the Upper Frame to the Vertical Frame with two M10 x 2 ½” Carriage Bolts (#60), one 4 3/8” x 1 ¾” Bracket (#22), two ∅ ¾” Washers (#70), and two M10 Aircraft Nuts (#72).

G.)Securely tighten all Nuts and Bolts installed in Step-1 and Step-2.

8