Assembly
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
STEP 1
Attach the Main Frame (#1) to the Front Stabilizer (#2). Align the holes and secure it with three M10×5/8" Allen Bolts (#31) and three 3/4" Washers (#39).
Attach the Main Frame (#1) to the Rear Stabilizer (#3). Align the holes and secure it with two M10×5/8" Allen Bolts (#31) and two 3/4" Washers (#39).
Slide the Sliding Block (#9) onto the Incline Adjustment Bar (#10). Align the holes then thread in a Knob Lock (#20) to hold the Sliding Block in position.
Push two Bushings (#23) into the Incline Adjustment Bar (#10). Then attach the Bar to the front bracket on the Main Frame (#1). Secure it with one M10×3" Allen Bolt (#33), two 3/4" Washers (#39) and one M10 Nylon Nut (#41).
Attach two Bushings (#23) to the side of Main Frame (#1). Attach two Bushings (#23) to the pivot on top of the Main Frame (#1). Attach two Bushings (#23) to the pivot on the Sliding Block (#9).
5