Esoteric AZ-1 manual Understanding the remote control unit

Page 11

Understanding the remote control unit

A
	G
B
	F
C
D	E

Note:

To simplify explanations, instructions in this manual refer to the names of the buttons and controls on the front panel only. Associated controls on the remote control will also operate similarly.

AON/STANDBY

Use the ON button to turn the unit on.

Use the STANDBY button to turn it standby.

BVOLUME

Use these buttons to adjust the volume.

CDIMMER

Use this button to change the brightness of the front panel display.

DSETUP

Use this button to enter or exit the setup mode.

EMUTING

Use this button to mute the sound.

FINPUT

Use these buttons to select an input.

GButtons for the basic operation of Esoteric SZ-1 or UZ-1 You can use these buttons to operate Esoteric SZ-1 or UZ-1. Point the remote control unit at the remote sensor of the SZ-1 or UZ-1.

Image 11

Contents Digital Pre Main Amplifier Important Safety Instructions Contents Before Use Speaker Connections Connection using speaker cables with banana plugsConnection using speaker cables with spades or bare wire When your speaker cable has bare wire at the endConnections Analog audio input terminals Line Signal GND connectionPower cord receptacle Digital audio input terminals DigitalData transfer rate How to connect multiple i.LINK-capable devicesLink Ieee Copyright protection system DtcpBattery Replacement Remote Control UnitRestoring factory settings How to insert the batteriesDisplay Front panel featuresFront Panel Understanding the remote control unit Select an input by turning the Input knob Basic OperationTo turn the unit off standby Display dimming Use the Dimmer button to cycle between these settingsMuting Word sync Basic SettingsUse the Word button to switch between Wout CH Channel IRC i.LINK remote control functionOFF default setting Wout Word sync output frequencyTurn the Input knob to change the Gain setting Gain Setting for Analog Audio InputPress and hold the Setup button for more than 2 seconds Example Name and skip setting of the Input knobTurn the Input knob to change the setting For European customers Disposal of your old appliance TroubleshootingSpecifications Teac Esoteric Company