Troubleshooting

In case you experience any problem with this unit, please take the time to look through this chart and see if you can solve the problem yourself before you call your dealer.

No power

eCheck the connection to the AC power supply. Check and make sure the AC source is not a switched outlet and that, if it is, the switch is turned on. Make sure there is power to the AC outlet by plugging another item such as a lamp or fan.

ePress the POWER switch of the main unit to turn it on.

Remote control doesn’t work.

ePress the POWER switch of the main unit to turn it on. eIf the batteries are dead, change the batteries.

eUse remote control unit within the range (5m /15ft) and point at the front panel.

eClear obstacles between the remote control unit and the main unit.

eIf a strong light is near the unit, turn it off.

There is no sound or only a very low-level sound is heard. eAdjust the volume by turning the VOLUME knob.

eSelect the proper source using the INPUT knob.

eCheck that the speakers and components are connected securely.

eCheck the operation of the connected component.

No i.LINK output.

eCheck the channel setting. One AZ-1 unit must be set to L/R channel when multiple AZ-1 units are connected.

No sound from a Super Audio CD.

eDigital audio from a Super Audio CD cannot go through the OPTICAL or COAXIAL terminals. Use the i.LINK (AUDIO) terminal.

No digital audio output.

eThe AZ-1 isn’t equipped with Dolby Digital/DTS/MPEG decoders. The digital output setting of the connected player must be PCM. Or use analog audio terminals.

Unstable sound.

eSpeaker polarity (+/_) is reversed. Check all speakers for correct polarity.

The i.LINK indicator blinks.

eTurn on the digital device connected to the i.LINK(AUDIO) terminal. When you don’t use the i.LINK terminal, turn the i_RC setting off.

The display shows “WRD ERROR!”

eThe connected unit may not be in word sync mode while the AZ-1 is in word sync mode. Check the word sync terminal for correct connection and the settings on the connected unit.

eThe received digital signal doesn’t much the sync signal.

The proper word sync frequencies for Super Audio CDs are 44.1, 88.2 or 176.4.

Buzzing noise produced at regular intervals.

eThe connected unit may not be in word sync mode while the AZ-1 is in word sync mode. Check the word sync terminal for correct connection and the settings on the connected unit.

Normally, if this problem occurs, the display reads “WRD ERROR!”, but this message does not appear when deviation in sync is too small and out of the word error detection threshold of the AZ-1.

If normal operation cannot be obtained, unplug the power cord from the outlet and plug it again. This resets the internal micro-computer which can be disturbed during electrical storms, power interruptions, et cetera.

For European customers

Disposal of your old appliance

1.When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC.

2.All electrical and electronic products should be disposed of separately from

the municipal waste stream via designated collection facilities appointed by the government or the local authorities.

3.The correct disposal of your old appliance will help prevent potential negative consequences for the environment and human health.

4.For more detailed information about disposal of your old appliance, please contact your city office, waste disposal service or the shop where you purchased the product.