Esoteric AZ-1 Gain Setting for Analog Audio Input, Turn the Input knob to change the Gain setting

Page 16

Gain Setting for Analog Audio Input

INPUT SETUP

You can adjust the relative volume between the LINE IN terminals. Once the relative volume is set, each component connected to the AZ-1 will have the approximate same volume level.

1Select an input to be changed (LINE1, LINE2 or LINE3/PHONO) by turning the INPUT knob.

Start with the component that has the lowest volume level.

2Press and hold the SETUP button for more than 2 seconds.

The unit enters setup mode, and “GainL*>***” appears on the display. (*** changes depending on your setting.)

If you leave the unit idle for 10 seconds, the setup mode will be cancelled.

3Turn the INPUT knob to change the Gain setting.

Adjustable range: 0, +3, +6, +9, +12, +15, +18, +21, +24

4Press and hold the SETUP button for more than 2 seconds (or leave the unit idle for 10 seconds) to exit the Gain setup mode.

<Settings are stored even when power is turned off and the unit is unplugged. If left unplugged for an extended period, the settings may be lost.

<If you lightly press the SETUP button, the unit enters name and skip setting mode. See page 17 for details.

16

Image 16

Contents Digital Pre Main Amplifier Important Safety Instructions Contents Before Use Connection using speaker cables with banana plugs Connection using speaker cables with spades or bare wireWhen your speaker cable has bare wire at the end Speaker ConnectionsConnections Signal GND connection Power cord receptacleDigital audio input terminals Digital Analog audio input terminals LineHow to connect multiple i.LINK-capable devices Link IeeeCopyright protection system Dtcp Data transfer rateRemote Control Unit Restoring factory settingsHow to insert the batteries Battery ReplacementFront Panel Front panel featuresDisplay Understanding the remote control unit To turn the unit off standby Basic OperationSelect an input by turning the Input knob Muting Use the Dimmer button to cycle between these settingsDisplay dimming Use the Word button to switch between Wout Basic SettingsWord sync IRC i.LINK remote control function OFF default settingWout Word sync output frequency CH ChannelPress and hold the Setup button for more than 2 seconds Gain Setting for Analog Audio InputTurn the Input knob to change the Gain setting Turn the Input knob to change the setting Name and skip setting of the Input knobExample Troubleshooting For European customers Disposal of your old applianceSpecifications Teac Esoteric Company