Esoteric AZ-1 manual Word sync, Basic Settings, Use the Word button to switch between Wout

Page 14

Word sync

This feature is used when you want to get your whole system locked to a single sync signal (clock) by connecting this unit to the Esoteric SZ-1/UZ-1 or other devices that are capable of inputting a sync signal (word clock).

Use the WORD button to switch between W_OUT and

WORD OFF.

W_OUT

The unit internally generates and sends out Word Clock. The indicator lights.

You can change the frequency of the word sync signal. See pages 14 and 15 for details.

<Make WORD SYNC connections before powering on the unit.

<It takes several seconds to detect and lock to a clock.

If the received digital signal doesn’t match the sync signal, the display shows “WRD ERROR!”.

WORD OFF

The unit does not output a word clock.

Basic Settings

INPUT SETUP

1Repeatedly press the SETUP button to select the menu item to be changed.

<If you leave the unit idle for 10 seconds, the setup mode will be cancelled.

2Turn the INPUT knob to select the options within the menu item.

<Repeat steps 1 and 2 as required.

3Repeatedly press the SETUP button (or leave the unit idle for 10 seconds) to exit the setup mode.

<Settings are stored even when power is turned off and the unit is unplugged. If left unplugged for an extended period, the settings may be lost.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Digital Pre Main Amplifier Important Safety Instructions Contents Before Use When your speaker cable has bare wire at the end Connection using speaker cables with banana plugsConnection using speaker cables with spades or bare wire Speaker ConnectionsConnections Digital audio input terminals Digital Signal GND connectionPower cord receptacle Analog audio input terminals LineCopyright protection system Dtcp How to connect multiple i.LINK-capable devicesLink Ieee Data transfer rateHow to insert the batteries Remote Control UnitRestoring factory settings Battery ReplacementDisplay Front panel featuresFront Panel Understanding the remote control unit Select an input by turning the Input knob Basic OperationTo turn the unit off standby Display dimming Use the Dimmer button to cycle between these settingsMuting Word sync Basic SettingsUse the Word button to switch between Wout Wout Word sync output frequency IRC i.LINK remote control functionOFF default setting CH ChannelTurn the Input knob to change the Gain setting Gain Setting for Analog Audio InputPress and hold the Setup button for more than 2 seconds Example Name and skip setting of the Input knobTurn the Input knob to change the setting Troubleshooting For European customers Disposal of your old applianceSpecifications Teac Esoteric Company
Top Page Image Contents