Weider 831.15707.0 user manual Repeat this step with the other Pad Tube, Same height

Page 8

5. Insert the Support Rod (14) into a set of holes in

5

 

 

the Uprights (1). Turn the Support Rod so the

 

 

 

 

 

locking pin is wrapped around the Upright.

 

 

 

Tighten the M10 Nylon Locknuts (31) and M10

14

1

 

x 19mm Screw (5) used in steps 1–4.

Locking

 

 

 

 

 

 

Pin

 

 

 

 

 

1

6. Lubricate the M10 x 60mm Bolt (25) with part of

6

 

 

the included grease packet. Attach the Leg Lever

 

 

 

 

 

(6) to the Front Leg (4) with the Bolt and an M10

31

 

 

Nylon Locknut (31). Do not overtighten the Nylon

 

 

 

Locknut; the Leg Lever must pivot easily.

6

 

 

 

25

 

 

 

 

 

4

 

 

 

 

Lubricate

 

7. Insert a Pad Tube (12) into the Leg Lever (6).

7

 

 

Slide a Foam Pad (13) onto each end of the Pad

 

 

 

 

 

Tube.

13

 

 

Repeat this step with the other Pad Tube (12).

6

 

 

 

 

 

 

 

12

 

 

 

 

13

 

 

12

 

8. Insert a Weight Rest (15) into an Upright (1). Turn

8

 

 

the Weight Rest so the locking pin is wrapped

 

 

 

1

 

around the Upright.

15

 

 

 

 

 

 

Repeat this step with the other Weight Rest

 

 

 

(15). Make sure that the Weight Rests are at

 

Locking

1

the same height.

 

 

 

Pin

 

 

 

 

 

 

15

 

 

8

 

 

Image 8
Contents Model No Serial No Sears, Roebuck and Co., Hoffman Estates, ILTable of Contents Important Precautions Before YOU Begin Part Identification Chart Assembly Make Assembly EasierLocknuts yet Attach the other end of the Crossbar 2 in the same wayLocknut or Screw yet Repeat this step with the other Pad Tube Same heightHoles Tube Lubricate Adjustment Adjusting the BackrestWeight Loss Exercise GuidelinesMuscle Building ToningCooling Down Page Part LIST-Model No Qty DescriptionR0407A DAY Full Warranty Get it fixed, at your home or ours