Weider WESY09320 Adjustments, Adding Weights to the Weight Carriage, Adjusting the Seat

Page 14

ADJUSTMENTS

This section explains how to adjust the weight system. See the EXERCISE GUIDELINES on page 18 for impor- tant information about how to get the most benefit from your exercise program. Also, refer to the accompanying exercise guide to see the correct form for each exercise.

Make sure all parts are properly tightened each time you use the weight system. Replace worn parts immediately. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.

ADDING WEIGHTS TO THE WEIGHT CARRIAGE

To add resistance to your workout, slide an equal amount of weight (not included) onto each side of the weight tube on the Weight Carriage (18). To use Olympic weights, slide an Adapter Tube (35) onto each side of the weight tube. Secure the weights with the two Clips (44). Note: Due to the cables and pul- leys, the actual amount of resistance at each exercise station may vary from the amount of weight used. Use the WEIGHT RESISTANCE CHART on page 16 to find the approximate amount of resistance at each weight station.

WARNING: Do not place more than 200 pounds on the Weight Carriage (18).

ATTACHING THE HIGH PULLEYS AND LEG LEVER

To attach a high pulley, slide the eyebolt on the Pulley Housing (21) onto the Eyebolt (34). Attach the end of the Short Cable (33) without the ball to the end of the Long Cable (80) with a Cable Clip (51). Attach the other high pulley in the same manner.

To use the Leg Lever (not shown), attach the ends of the Bench Cable (32) to the ends of the Long Cable (80) with two Cable Clips (51).

Remove the high pulleys, or detach the Bench Cable (32), when not in use.

ADJUSTING THE SEAT

The Seat (13) can be secured to any of four positions on the Bench Frame (5). To move the Seat, remove the Seat Pin (45) and slide the Seat to the desired position. Engage the Seat Frame (12) and an adjust- ment hole in the Bench Frame with the Seat Pin.

For some exercises the Seat Frame (12) must be able to roll freely on the Bench Frame (5). To allow this to happen, remove the Seat Pin (45) from the Seat Frame.

Weight

18

 

Tube

 

35

 

44

34

21 Ball

33

80

51

32

51

13

 

45

5

12

 

14

Image 14
Contents Customer HOT Line QUESTIONS?Model No. WESY09320 Serial No Table of Contents Important Precautions Dimensions Before YOU BeginAssembly Make Things Easier for YourselfPage Page Page Locknut the Small Wheels must be able to roll easily Page Page Eyebolt Page Adjusting the Seat AdjustmentsAdding Weights to the Weight Carriage Attaching the High Pulleys and LEG LeverStoring the Weight System Attaching the AccessoriesAdjusting the Backrest Weight Resistance Chart Weight High Pulley LOW Pulley LEG LeverCable Diagram Long CableExercise Guidelines Staying Motivated Muscle ChartCooling Down Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty Part Identification Chart M10 Nylon Locknut M10 Washer M8 Nylon Locknut Part LIST-Model No. WESY09320 Qty DescriptionR0702A