ASSEMBLY
Make Things Easier for Yourself
Everything in this manual is designed to ensure that the weight system can be assembled suc- cessfully by anyone. However, it is important to realize that the versatile weight system has many parts and that the assembly process will take time. Most people find that by setting aside plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the following information and instructions:
•Assembly requires two people.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•As you assemble the weight system, make sure all parts are oriented as shown in the drawings.
•For help identifying small parts, use the PART IDENTIFICATION CHART in the center of the manual.
The following tools (not included) are required for assembly:
•Two adjustable wrenches
•One rubber mallet
•One standard screwdriver
•One Phillips screwdriver
•Lubricant, such as grease or petroleum jelly, and soapy water.
Assembly will be more convenient if you have a socket set, a set of
1.
Before beginning assembly, make sure you have read and understood the information in the box above. This brief introduction will save you more time than it takes to read it!
Press two 45mm Square Inner Caps (42) into the ends of the Base (1).
Attach two Plastic Feet (53) to the Base (1) with two M4 x 16mm Screws (56).
Attach a Wheel (31) to the outside of the Base (1) with an M10 x 103mm Bolt (81), three M10 Washers (75), and an M10 Nylon Locknut (76).
Do not overtighten the Locknut; the Wheel must be able to turn easily.
Attach the other Wheel in the same manner.
2.Attach the Base Plate (2) to the Base (1) with two M4 x 16mm Screws (56).
1 |
| 42 |
|
|
| 31 | |
|
|
| |
42 | 75 | 76 |
|
31 |
|
|
|
81 | 75 |
|
|
| 1 |
| |
|
| 53 | |
|
|
| |
|
|
| 53 |
|
|
| 56 |
2 |
|
|
|
2 |
1
56
5