Weider WESY09320 user manual

3.Insert two M10 x 61mm Carriage Bolts (83) into the bottom of the Base (1). Set the Base flat on the floor. Attach the Upright Base (3) to the Base with the Bolts and two M10 Nylon Locknuts (76).

4.Attach the Upright (4) to the Upright Base (3) with four M10 x 25mm Button Bolts (68) and four M10 Split Washers (43).

3

3

76

1

83

4

4

43

68

43 3

5.Note: The Carriage Stop (37) has been pre-insert- ed into the Nylon Outer Bushing (74). Slide the Nylon Outer Bushing onto the Rear Upright (8); make sure that the visible edge of the Carriage Stop (37) is on the bottom.

Attach the Nylon Outer Bushing (74) to the Rear Upright (8) at the second hole from the bottom with an M8 x 65mm Bolt (67) and an M8 Nylon Locknut (65).

Attach the Rear Upright (8), with the indicated holes on the front side, to the Base (1) with an M10 x 60mm Bolt (63), two M10 Washers (75), and an M10 Nylon Locknut (76).

5

Holes

8

65

75

76

67

63

75

74

1 37

6