Weider WEBE29300 manual

Page 7

3.Attach an Upright (1) to each Base (7) using two Joint Plates (12), four M10 x 80mm Bolts (41), and four M10 Nylon Locknuts (11). Make sure the Uprights are oriented exactly as shown. Do not tighten the Nylon Locknuts yet.

4.Insert a Weight Guide (18) into the indicated hole in each Base (7). Attach the Weight Guides to the Bases using M10 x 75mm Bolts (39), M10 Small Washers (6), and M10 Nylon Locknuts (11). Do not tighten the Nylon Locknuts yet.

5.Press a 25mm Bushing (48) into each end of the Locking Bar (34). Slide the Barbell (35) into the Locking Bar (34).

3
1
41
7	1
12
		7
12
	11
	12
	12
	41
4
18
39
6	7
6
6
11	18
	18
	11	39
	6	39
	6
	7	6
	7
5
48	34
		35
	48

7

Image 7

Contents Customer HOT Line Model No. WEBE29300 Serial NoMon.ÐFri., 6 a.m.Ð6 p.m. MST R N I N G Table of ContentsImportant Precautions Right Side Before You BeginLeft Side Part Identification ChartÑModel No. WEBE29300 R0800A Some small parts may be pre-assembled AssemblyLocknuts yet Page Weight Gliders are oriented exactly as shown Make sure the Safety Spotters are oriented exactly as shownTighten the M8 x 16mm Screws 50 used in steps 6 Carriage and the Rear Upright are oriented as shown Locknut the Pulley must be able to turn freely Tighten all Nylon Locknuts used in steps 1 throughNylon Locknut the Pulley must be able to turn freely Page Seat is turned as shown Page Using the Locking BAR Adjusting the Weight BenchUsing the Safety Spotters Removing the Foam Pads Attaching Weights to the Barbell or the Weight CarriageAttaching Weights to the LEG Lever Tightening the CablesKnob Attaching the Weight AdapterAdjusting the Backrest Attaching the Curl PADExercise Guidelines Cooling Down Muscle ChartStaying Motivated Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Remove this Part LIST/EXPLODED Drawing From the Manual Qty Description Part ListÑModel No. WEBE29300Exploded DrawingÑModel No. WEBE29300