3.Tap a 45mm Square Inner Cap (21) into the Front Leg (8) as shown. Attach the Front Leg to the Frame (2) with two M10 x 65mm Bolts (18), two M10 Washers (24), and two M10 Nylon Locknuts (19).
4.Tap two 45mm Square Inner Caps (21) into the Leg Lever (4) as shown.
Tap a 1Ó Round Inner Cap (23) into the indicated end of the Weight Tube (33). Insert the Weight Tube into the Leg Lever (4). Make sure the
Weight Tube is angled up so that weights will not slide off. Press the 1Ó Angled Cap (29) onto the other end of the Weight Tube.
5.Lubricate the M10 x 72mm Bolt (14). Attach the Leg Lever (4) to the Front Leg (8) with the Bolt and an M10 Nylon Locknut (19). Do not overtight- en the Nylon Locknut; the Leg Lever must be able to pivot freely.
Attach the Spacer (37) to the Leg Lever (4) with the M8 x 58mm Bolt (39), two M8 Washers (38), and an M8 Nylon Locknut (13). Note: The Spacer will fit tightly inside the Leg Lever.
6.Press four 1Ó Square Inner Caps (12) into the Backrest Tubes (5, 26). Press two 1Ó x 2Ó Inner Caps (36) into the adjustment tubes.
With the wide end of the Backrest (6) positioned as shown, attach the Backrest Tubes (5, 26) to the Backrest with four M6 x 38mm Screws (16) and four M6 Washers (25). Note: The Backrest
Tubes and the Backrest must be oriented exactly as shown.
7
3 | 19 |
| |
21 |
| ||
|
| ||
24 |
| 2 | |
18 | 19 |
| |
8 |
|
| |
4 |
|
| |
21 |
|
| |
|
| 4 | |
33 |
|
| |
|
| 29 | |
23 |
|
| |
21 |
|
| |
5 |
|
| |
19 | 8 |
| |
4 |
|
| |
39 | 14ÐLubricate | ||
38 37 | |||
|
| ||
38 |
|
| |
13 |
|
| |
6 |
|
| |
6 |
|
| |
Wide |
| 12 | |
End |
|
| |
5 |
| 25 | |
|
| ||
| 26 | 16 | |
12 | Adjustment | ||
25 | 25 | Tubes | |
16 |
| ||
36 | 16 |
| |
|
| ||