6.Lubricate the M10 x 70mm Bolt (26). Attach the Leg Lever (4) to the Front Leg (8) with the Bolt, two M10 Washers (29), and an M10 Nylon Locknut (30).
Note: Do not overtighten the M10 Nylon Locknut (10); the Leg Lever (4) must be able to pivot freely.
7.Press two 19mm Round Inner Caps (12) into each Pad Tube (10).
Insert the Pad Tubes (10) into the holes in the Leg Lever (4). Slide two Foam Pads (22) onto each Pad Tube.
8.Press a 25.4mm Square Inner Cap (18) into the indicated end of each Backrest Tube (5).
Attach each Backrest Tube (5) to the Backrest (6) with two M8 x 40mm Bolts (27) and two M8 Washers (17). Note the position of the indicated holes in the Backrest Tubes; they must be ori- ented as shown. Do not tighten the four Bolts yet.
9.Press a 25.4mm Square Inner Cap (18) into each end of the Support Tube (7). Set the Support Tube into the highest set of adjustment brackets on the Uprights (1, 15).
Lubricate the M10 x 130mm Bolt (9). Attach the Backrest Tubes (5) to the Frame (2) with the Bolt, two M10 Washers (29), and an M10 Nylon Locknut (30). Do not overtighten the Nylon Locknut.
Rest the Backrest (6) on the Support Tube (7).
Tighten the Nylon Locknuts used in steps
8
6 |
|
|
|
|
| 30 29 | 8 |
| 4 |
|
|
|
|
| 29 |
|
|
| 26 |
|
|
| Lubricate |
7 |
|
|
|
22 |
|
| |
|
|
| 8 |
| 12 | 4 |
|
|
|
| |
22 |
| 12 |
|
10 |
|
|
|
|
|
| 22 |
8 |
|
|
|
|
| 27 | 18 |
|
|
| |
|
| 17 | 5 |
| 27 |
| |
|
|
| |
17 |
|
| 6 |
5 |
|
|
|
Holes |
|
| |
9 |
|
| 18 |
|
|
| |
|
|
| 7 |
| 1 |
|
|
9 | 29 |
| 15 |
|
| 5 |
|
2 |
| 29 |
|
|
|
| |
|
| 30 | |