9.Press two 25mm Round Inner Caps (21) into the weight tube of the Weight Carriage (12). Press two 45mm x 38mm Outer Bushings (23) onto the top and bottom of the Weight Carriage.
Insert an M8 x 16mm Bolt (44) into the bracket on the Weight Carriage (12). Slide the Weight Carriage onto the Lat Tower (11) as shown.
Route the Cable (25) through the slot of the Lat Tower (11) in the indicated direction. Connect the eyelet on the Cable to the Weight Carriage (12) using the M8 x 16mm Bolt (44) and an M8 Nylon Locknut (43).
10.Press a 38mm Square Inner Cap (32) into the top of the Lat Tower (11).
Route the Cable (25) around the Pulley (26) as indicated. Attach the Pulley inside the slot in the Lat Tower (11) with an M10 x 55mm Bolt (49), two M10 Washers (29), two M10 Spacers (42), and an M10 Nylon Locknut (45). Do not overtighten the Nylon Locknut; the Pulley must be able to turn freely.
Attach the Cable Clip (35) to the end of the Cable (25).
11.Slide the Lat Tower (11) into the Front Leg (2). Tighten it in place with the 44mm Adjustment Knob (34).
12.Wet the ends of the Lat Bar (18) with soapy water. Slide a Handgrip (19) onto each end of the Lat Bar. Attach the Lat Bar to the Cable Clip (35) and place it in the lat bar rest on the Lat Tower (11).
8
9 |
|
|
|
| Slot |
|
|
|
|
| 11 |
| 25 |
| 23 |
|
|
| |
| 21 |
| 44 |
|
|
| |
| 43 |
| Bracket |
|
| 12 | |
|
|
| |
| Weight |
| 21 |
|
| 23 | |
| Tube |
| |
10 | 29 | 42 | 32 |
|
| ||
| 45 |
| 42 |
|
|
| |
| 26 |
| 29 |
|
|
| |
|
|
| 49 |
| 11 | 25 | |
|
| ||
|
|
| 35 |
11 |
|
|
|
|
|
| 34 |
| 11 |
|
|
| 2 |
|
|
12 | 19 |
|
|
|
|
| |
| 18 |
| 19 |
|
|
| |
|
|
| Lat Bar |
|
|
| Rest |
| 11 | 35 |
|
|
|
| |