6.Press three 50mm Square Inner Caps (37) into the Leg Lever (4). Press a 50mm Round Inner Cap (19) into the weight tube.
Press two 8mm Bushings (14) into the Leg Lever Bracket (7).
Lubricate the M10 x 78mm Bolt (29). Attach the Leg Lever (4) to the Leg Lever Bracket (7) with the Bolt and an M10 Nylon Locknut (33). Do not overtighten the Nylon Locknut; the Leg Lever must pivot freely.
7.Attach the Seat (11) to the brackets on the Seat Frame (5) using two M6 x 16mm Bolts (26). Attach the other end of the Seat to the Seat Frame with an M6 Washer (34) and an M6 x 50mm Bolt (23).
8.Press four 19mm Round Inner Caps (17) into the ends of the two Pad Tubes (16).
Insert the Pad Tubes (16) into the holes in the Leg Lever (4). Slide two Foam Pads (18) onto each Pad Tube.
9.Make sure that all parts of the weight bench are properly tightened.
6 |
|
| 14 |
| 37 | 33 | |
|
| ||
37 | 4 |
| 7 |
|
|
| |
19 |
|
| 29 |
Weight Tube |
|
| |
| 37 |
|
|
7 |
|
|
|
| 11 |
|
|
| 26 |
|
|
| 34 |
|
|
| 23 | 5 |
|
|
|
| |
|
| 26 |
|
8 |
|
|
|
18 |
|
|
|
| 4 |
|
|
|
| 17 |
|
|
| 16 |
|
|
|
| 17 |
|
|
| 18 |
8