Weider WESY59531 user manual Attaching the Accessories, Adjusting the Resistance

Page 14

ATTACHING THE ACCESSORIES

To attach a Short Handle (49) to a high pulley, first attach the high pulley to the resistance system (see

ATTACHING THE HIGH PULLEYS AND LEG LEVER on page 13). Then, attach the Short Handle to the Short Cable (33) with a Cable Clip (51).

The Long Handles (not shown) and the Ankle Strap (not shown) can be attached to the Long Cable (80) with Cable Clips (51). Attach the Leg Press Strap (not shown) to both ends of the Long Cable, or the optional lat bar to the Short Cables (33), with two Cable Clips.

Note: A lat bar is an optional accessory for the resistance system. To purchase a lat bar, call our Customer Service Department toll-free at 1-877-992- 5999 and ask for model number WEMC0442.

ADJUSTING THE RESISTANCE

To add resistance, hold a “U”-channel on the 10- Pound Center Resistance Bar (44) firmly and push the end of a resistance bar under it. Repeat with the other end of the resistance bar. If more resistance is need- ed, add one resistance bar at a time.

Note: When adding resistance, always start with the heaviest resistance bar to be used, and finish with the lightest resistance bar. When removing resistance bars from the “U”-channels, start with the lightest resistance bar and finish with the heaviest.

WARNING: When adding resist- ance, make sure that both ends of the resist- ance bar rest under the two “U”-channels. The rings on the Removable Resistance Bars (36,

67)must be pushed against the Tray (35). Do not add or remove resistance bars from the “U”-channels while the end of the Long Cable (80) is pulled out.

Note: The resistance system uses progressive resist- ance. As the resistance bars begin to bend, the amount of resistance will increase gradually. As the resistance bars bend further, the resistance will increase rapidly.

Additional resistance can be added to the resistance system by calling our Customer Service Department at 1-877-992-5999 and asking for model number WEMC0642 (100-Pound Power Pak) or WEMC0942 (200-Pound Power Pak).

33

51

49

80

“U”-Channel

Resistance

Bars

35

67

36

44

“U”-Channel

80

14

Image 14
Contents Customer HOT Line QUESTIONS?Model No. WESY59531 Serial No Table of Contents Important Precautions Dimensions Before YOU BeginAssembly Make Things Easier for YourselfPage Page Knob is aligned with the slot in the Seat Carriage, as shown Page Locate the Long Cable 80. Insert one end Edge of the Pulley Guard is on the side ShownEdge of the Pulley Guard is on the side Shown Onto the hook welded to the bottom of the Bench Rail Attaching the High Pulleys and LEG Lever AdjustmentsAdjusting the Seat Attaching the Accessories Adjusting the ResistanceAdjusting the Backrest Storing the Resistance SystemMake sure the rings are pushed against the Tray Cable DiagramUsing the Removable Resistance Bars Long CableExercise Guidelines Staying Motivated Muscle ChartCooling Down Aerobic Exercise DateExercise Resistance Sets Reps Thursday Aerobic Exercise DatePage Part Identification Chart Part LIST-Model No. WESY59531 Qty DescriptionExploded DRAWING-Model No. WESY59531 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty