Weider WESY39522 user manual

Page 18

49.Wrap the Swivel Low Cable (72) over a 3 1/2” Pulley (78). Attach the Pulley and a Cable Trap (68) between the lower set of holes in the “U”-bracket (64) with a 3/8” x 2” Bolt (100) and a 3/8” Nylon Locknut (87). Make sure that the Cable Trap is turned to hold the Cable in the groove of the Pulley.

50.Attach the end of the Swivel Low Cable (72) inside of the Short Base (2) with a 5/16” x 2 1/2” Bolt (59), two 5/16” Washers (90), and a 5/16” Nylon Locknut (86).

51.Locate the Squat Cable (73), which is the only remaining cable. Attach the eyelet end of the Cable inside of the Long Base (120) with a 5/16” x 2 1/2” Bolt (59), two 5/16” Washers (90), and a 5/16” Nylon Locknut (86).

52.Wrap the Squat Cable (73) over a 3 1/2” Pulley

(78).Attach the Pulley, a Cable Trap (68), and two 3/4” Spacers (124) between the indicated brackets on the Squat Slider (38) with a 3/8” x 3 1/4” Bolt

(96)and a 3/8” Nylon Jamnut (113). Make sure that the Cable Trap is turned to hold the Cable in the groove of the Pulley.

18

49
100		64
68		64
68		87
72		87
72		78
		78
50
86 90
72	90	59
2
51
	73
		86
		90
		120
90
59
52
68 124
78		113
124		113
124
		38
	96
73

Image 18

Contents QUESTIONS? Model No. WESY39522 Serial NoCustomer HOT Line Table of Contents Important Precautions DecalFor your benefit, read this manual carefully before Using the weight system. If you have additionalBefore YOU Begin DecalAssembly Frame Assembly Locknuts yet Do not tighten the Nylon Locknuts yetPage Assemble the other weight stack in the same way Open the parts bag labeled ARM Assembly Do not tighten the Locknuts yetCable Assembly Repeat this step with the Left Butterfly ArmTrap is turned to hold the Cable in the groove of the Pulley 100 68 78 126 101 102 Trap is turned to hold the Cable in the groove of the Pulley Page Page Page Seat Assembly Locate and open the parts bag labeled Seat AssemblyRepeat this step with the other end of the Squat Arm Nylon Locknuts yetTighten all of the 3/8 Nylon Locknuts 87 used in this step Page Converting the Butterfly Arms AdjustmentsChanging the Weight Setting Ing any exerciseAdjusting the Squat ARM, SEAT, or Butterfly Backrest Adjusting the Squat Knee RestWeight Resistance Chart StationLbs Top Troubleshooting Tightening the CablesCable Diagrams Lat CableButterfly Cable Swivel High Cable Squat Cable Leg Lever Swivel CableSwivel Low Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Page Part Identification CHART-Model No. WESY39522 R1202AX 7 Bolt Page Remove this Part LIST/EXPLODED Drawing From the Manual Part LIST-Model No. WESY39522 Key Qty DescriptionExploded