Weider WESY5993.3 user manual

9.Press two 38mm Round Inner Caps (38) into the ends of the Top Frame (10).

Attach two Eyebolts (34) to the Top Frame (10) with two M8 Washers (59) and two M8 Nylon Locknuts (65). Do not overtighten the Locknuts; the Eyebolts must be able to rotate freely.

Attach the Top Frame (10) to the Lat Tower (4) with two M10 x 65mm Button Head Screws (70), two M10 Washers (75), and the Top Frame Cover

(93).Make sure that the Eyebolts (34) are ori- ented as shown in the inset drawing. If they are not, turn the Top Frame around and reat- tach it.

10.Attach the two 10-pound Short Caps (20) to the 10-pound Center Resistance Bar (44) with two M4 x 12mm Flat Head Screws (85).

Using ten M4 x 12mm Flat Head Screws (85), attach the two 10-pound Caps (101) to the 10- pound Removable Resistance Bar (67), the two 20-pound Caps (88) to the 20-pound Removable Resistance Bar (36), the four 80-pound Caps

(100)to the two 80-pound Resistance Bars (95), and the two 40-pound Caps (79) to the 40-pound Resistance Bar (96).

11.Locate the Fulcrum (18) on the Lat Tower (4) (see the inset drawing). Slide the Tray (35) onto the rods on the Fulcrum. Make sure the Tray is ori- ented as shown in the drawing.

Set the Resistance Bars into the Tray (35) in the following order: the 10-pound Removable Resistance Bar (67), the 20-pound Removable Resistance Bar (36), an 80-pound Resistance Bar (95), the 10-pound Center Resistance Bar (44), an 80-pound Resistance Bar (95), and the 40-pound Resistance Bar (96). Make sure the indicated rings are on the side shown and the arrows point toward the Tray.

Attach the Cover Plate (72), with the edges up, to the Tray (35) with two M8 x 19mm Button Head Screws (86).

9
65	70
		75
59
		93
38		10
			65
34
			59
			38
Side View		34		4
10
4
34
10
			96
		95			79
		36		85
	67
	44	85	85		100
			88
		85
		101
85		20
11		86
		72	Edges
			up
				96
Rings on
this side
			44
	35				95
					95
	18
4			67		36
		Rods
18

8