Do not overtighten the Locknut the Leg Lever

12. Press two 25mm Square Inner Caps (54) into the	12
indicated end of the Backrest Frame (15).	12
indicated end of the Backrest Frame (15).
Attach a Plastic Foot (53) to the Backrest Frame	14
(15) with an M4 x 16mm Screw (62).	14
(15) with an M4 x 16mm Screw (62).
Orient the Backrest (14) and the Backrest
Backing (8) as shown. Attach the Backrest and
the Backrest Backing to the Backrest Frame (15)
with four M6 x 45mm Screws (58).	8
	8
	15		53
			62
		58
	54	58
13. Insert the rod on the Backrest Frame (15) into the	13
slot in the Seat Carriage (12). Hold the Backrest	13
slot in the Seat Carriage (12). Hold the Backrest
Frame vertically over the Seat Carriage and
slide the rod into the slot, as shown in the
inset drawing.
	Rod
	15
		15
		Rod
			Slot
	12
			12
14. Press two 50mm Round Inner Caps (57) into the	14
top and bottom of the Leg Developer (19). Press	14
top and bottom of the Leg Developer (19). Press
two 45mm Round Inner Caps (56) into the top		Tube	57
and bottom of the Leg Lever (7).		Tube	57
and bottom of the Leg Lever (7).
Lubricate an M10 x 69mm Bolt (60) with grease.		76
Attach the Leg Lever (7) to the Leg Developer	56		60
(19) with the Bolt and an M10 Nylon Locknut (76).	78	19	60
Do not overtighten the Locknut; the Leg Lever	Tube	19	Lubricate
Do not overtighten the Locknut; the Leg Lever		7
must be able to pivot easily.
must be able to pivot easily.
Press two 19mm Round Inner Caps (78) into the	26		57
	26

tube on the Leg Lever (7). Slide two Foam Pads		78
(26) onto the tubes. Repeat with the tube on the	56	78
(26) onto the tubes. Repeat with the tube on the
Leg Developer (19).
Leg Developer (19).

Do not overtighten the Locknut; the Leg Lever

must be able to pivot easily.

(26) onto the tubes. Repeat with the tube on the

Leg Developer (19).