Weider WESY5983.5 user manual Flat edge of the Pulley Guard is on the side Shown

20. Wrap the Long Cable (80) under a 90mm Pulley	20
(28) as shown. Attach the Pulley and a Pulley
Guard (29) to the Upright (3) with an M10 x
113mm Button Head Bolt (40) and an M10 Nylon		3
Locknut (76). Make sure the flat edge of the				28
Pulley Guard is on the bottom.
	40			76
				29
				80
				Flat
				Edge
21. Attach a Pulley Housing (94) to the indicated “U”-	21
channel on the 10-pound Center Resistance Bar
(44) with an M10 x 102mm Bolt (24), two Pivot
Bushings (74), and an M10 Nylon Locknut (76).		44
Wrap the Long Cable (80) around a 90mm Pulley		74		74
(28). Attach the Pulley inside of the Pulley		94		76
Housing (94) with an M10 x 42mm Button Head	24			76
Bolt (71) and an M10 Nylon Locknut (76).
		71
				28
				80
22. Wrap the Long Cable (80) around a 90mm Pulley	22
(28). Attach the Pulley and a Pulley Guard (29) to
	28
the indicated M10 x 140mm Carriage Bolt (73)				29
with an M10 Nylon Locknut (76). Make sure the
flat edge of the Pulley Guard is on the side
shown.	80			76
		Flat
23. Make sure there are no Resistance Bars (not		Edge
shown) under the “U”-channels on the 10-pound				73
Center Resistance Bar (not shown). Have a sec-
ond person pull on the Long Cable (80) to create
slack in the Cable.	23
Insert the end of the Long Cable (80) through the
welded tube on the indicated end of the Cross
Tube (11) and then through the remaining Swivel			22	71
Arm (22). Be sure the Cable is on the indicated		Rod		104
side of the welded rod in the Swivel Arm.
	80
Insert the Swivel Arm (22) into the welded tube				11
on the Cross Tube (11). Secure the Swivel Arm		28	76
with an M4 x 5mm Screw (104).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Swivel Arm
(22) with an M10 x 42mm Button Head Bolt (71)
and an M10 Nylon Locknut (76).
	11