Weider WESY85290 manual Cable Trap is turned to hold the Cable, Place and that the Cable is routed

22.Locate the Short Cable (58). Route the Short Cable under the 3 1/2Ó Low Pulley (77).

Be sure that the end of the Cable with the ball is on the indicated side of the Pulley and that the Cable is between the Pulley and the welded spacer on the Leg Lever (29). Tighten the 3/8Ó x 3 1/2Ó Bolt (16) and the 3/8Ó Nylon Locknut (not shown).

23. Wrap the Short Cable (58) around a ÒVÓ-

	Pulley (6). Attach the Pulley and a Long
	Cable Trap (50) inside the bracket on the
	Seat Frame (36) with a 3/8Ó x 2 1/2Ó Bolt (7)
	and a 3/8Ó Nylon Locknut (21). Be sure that
	the Cable Trap is turned to hold the Cable
	in place and that the Cable is routed
	around the Pulley as shown.
ASSEMBLY	24. Wrap the Short Cable (58) around a 3 1/2Ó
CABLE	Pulley (15). Attach the Pulley to the Rocker
	turned to hold the Cable in place and that
	Arm (32) with a 3/8Ó x 3 1/2Ó Bolt (16), a 3/8Ó

Flat Washer (9), and a 3/8Ó Nylon Locknut (21). Be sure that the Cable Trap (66) is

the Cable is routed around the Pulley as shown.

25.Note: The 3 1/2Ó Pulley (15) labeled in this step is pre-attached. It is shown removed for easy part identification.

Route the Short Cable (58) around the 3 1/2Ó Pulley (15) attached to the lower hole in the Front Upright (42). Be sure that the Cable

Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the 3/8Ó Nylon Locknut (21) and the 3/8Ó x 3 3/4Ó Bolt (71).

12

22
	29
	16
58	77		Ball
		Welded Spacer
23
6	58
	21
50	7
	36
24		66
	15
			16
32			58
21
9
25
42
	71
15	66
21	58
9