Weider WESY78732 user manual Do not tighten the Locknut yet, Not tighten the Bolt yet

8.	Attach a Large Pulley (14) and the Pulley Plate	8
	(68) to the Upright (2) with an M12 x 62mm
	Button Bolt (81) and an M12 Nylon Locknut (13).			68
	Do not tighten the Locknut yet.				13
				14
		81		2
9.	Pull the upper cable (A), which is attached inside	9
	of the Mech Frame (not shown), up between the
	Upright (2) and the Pulley Plate (68).
					A
	Attach another Large Pulley (14) to the Upright (2)			90	11
	and Pulley Plate (68) with an M12 x 62mm Button
	Bolt (81) and an M12 Nylon Locknut (13). Make			13
	sure that the upper cable (A) is between the
	two Pulleys.			68
	Hold the 38mm Spacer (90) inside the loop of the	81		2	14
	upper cable (A), and between the Upright (2) and
	the Pulley Plate (68). Attach the Spacer with an
	M10 x 58mm Button Screw (11). Make sure the
	ends of the cable do not wrap around each
	other below the Spacer and the Large Pulleys
	(14) used in steps 8 and 9 (refer to the CABLE
	DIAGRAM on page 18).
	Tighten the M12 Nylon Locknuts (13) used in
	steps 8 and 9.
10.	Attach a Small Guide Spacer (18), a Large Guide	10
	Spacer (17), and two Crossbar Guides (15) to the
	Upright (2) with an M10 x 152mm Bolt (86).
	Pull the upper cable (A) up between the Crossbar		17
	Guides (15). Press the metal cover on the cable	18
					86
	into the groove in the Crossbar Block (16). Attach
	a Small Guide Spacer (18), the Crossbar Block,		15
	the two Crossbar Guides (15), an M10 Thick			Metal
					54
	Washer (54), and the two Tethers (70) to the	2	A	Cover
	Upright (2) with another M10 x 152mm Bolt (86). Do
	not tighten the Bolt yet.				86
					70
		18	16	Groove

9