Weider WESY85100 On each Arm. Arm identification is very, Important for step, Inset drawing

8. Press a 1 3/4” Square Inner Cap (44) into the

top of a Press Arm (46). Press a 1” Round

Inner Cap (49) into each end of the handle on

the Press Arm. Attach the Press Arm to one

side of the Press Frame (17) with two 5/16” x

2 1/2” Bolts (22) and two 5/16” Nylon

Locknuts (3).

Assemble the other Press Arm (46) in the

same manner.

9. Identify the Right Arm (48) and the Left Arm

(47). Note the position of the welded bracket

on each Arm. Arm identification is very

important for step 10.

Note: The “V”-Pulleys (6), Long Cable Traps

(50), 3/8” x 2 1/2” Bolts (7), and 3/8” Nylon

Locknuts (21) are pre-attached. These have

been shown disassembled for easy part iden-

tification.

8 44

49

	44
		49
				46
49
46
			22

3

17

9	50	7	50
			6

6

Welded	47
Brackets
	21
48

ARM ASSEMBLY

10. Lubricate both axles on the Top Frame (55).

Slide the Right Arm (48) onto the right axle.

Note: Be careful not to confuse the Right

Arm with the Left Arm (47); refer to step 9

to identify the Right Arm. Be sure that the

upper end of the Right Arm is behind the

indicated bracket on the Top Frame (55).

Tap two 1” Retainers (69) and a 1” Round

Cover Cap (70) onto the right axle. Be sure

that the teeth on the Retainers bend

toward the Cover Cap, as shown in the

inset drawing.

Attach the Left Arm (47) in the same manner.

Press 1 3/4” Square Inner Caps (44) into the

lower ends of the Right and Left Arms (47,

48). Wet the lower end of each Arm with

soapy water. Slide a 10” Pad (45) onto the

lower end of each Arm.

10

55

48

44

45

47

Bracket

Lubricate Axle

69

70 45

55

69

70

8