8.Orient the two Pivot Bars (14) so that the Pulleys (22) face away from the Center Frame (13). Then, insert the Pivot Bars into the brack- ets on the ends of the Center Frame, and engage the pins on the brackets into the cen- ter adjustment holes in the Pivot Bars.
Insert the two Pulleys (22) down into the slots in the Saddle Plates (18).
See step 2. Tighten the four M8 Locknuts (54).
9.Pull the Short Adjustment Knob (19), and insert the end of the Adjustment Frame (7) a few inches into the Backrest Frame (6). See the inset drawing. Press the round tab on the Backrest Frame Bushing (25), and press the Backrest Frame Bushing into the Backrest Frame (6). Make sure that the round tab is in the indicated hole in the Backrest Frame.
Next, insert the Adjustment Frame (7) farther into the Backrest Frame (6), and engage the Short Adjustment Knob (19) into one of the adjustment holes in the Adjustment Frame. Then, insert the Pin (24) into the Backrest Frame (6) and the Adjustment Frame (7), and attach the Pin Clip (63) to the Pin.
Use the inversion system with the Adjustment Frame (7) adjusted to a few different lengths to determine which length is the best for you.
8 |
|
|
|
|
22 | 14 | 22 |
|
|
Pin |
|
|
| |
13 | 14 |
|
| |
18 | Pin |
|
| |
| 18 |
|
| |
|
|
|
| |
9 |
|
| 6 |
|
|
|
|
| |
|
| 63 | 19 | 24 |
|
| 7 |
| |
|
|
|
| |
|
| TabHole | 6 | |
|
|
|
| 25 |
9 |
|
|
|
|