Haier HWM130-0713S Install the lint filter, How to change the direction of the drain hoses

Install the lint filter

Put the underside of the lint filter into overflow filter then push the upside into overflow filter.

After installation, please refer that the lint filter installed to the right station, otherwise the lint filter may be fallen off when washing, influencing your use.

overflow filter

lint filter

How to change the direction of the drain hoses

Figure 1 indicates the ex factory installation
position of the drain hose.	Soft item

Extend the drain hose from the side of spin tub

Back

Front

Figure 1

Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. Take off the drain hose from the cabinet. Take the hose out of the fixing groove. (See to Figure 2).

Soft item

Embed the drain hose into the groove along the side of the spin tub in the order of (1)~(3), heading for the side of the spin tub. (See to Figure 3).

Embed the drain hose into the groove with hands. Take care not to damage the drain hose in fastening the fixing clamp.

Extend to the spin tub side

Figure 2

Embed into the groove in turn

Figure 3

Install the water inlet hose; Select the water level

Insert the water inlet hose into the water-fillingWater inlet hose
entrance on the control pane directly.(pull it	Water inlet
out to dismantle it)

Select water level according to the quantity of the laundries.

Set the water level adjusting lever to needed line.

	Water level
	indicator
Maximum	Max
Medium	Med
Minimum	Min

5