INSTALLATION INSTRUCTIONS
ToolsandParts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Parts needed for washer (not provided):
Inlet hoses |
| Flat washers |
| ||
|
To order:
Call the dealer from whom you purchased your washer/dryer.
Call the
Visit the website listed on the cover of the Washer/Dryer User Instructions.
NOTE: Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Record hose installation or replacement dates for
AlternateParts
Your installation may require additional parts. For information on ordering, please refer to the toll free phone numbers on the front page of the Washer/Dryer User Instructions.
If You Have | You Will Need to Buy |
|
|
Laundry tub or | Sump pump system (if not already |
standpipe taller than | available) |
96" (2.4 m) |
|
|
|
1" (25 mm) diameter | 2" (51 mm) diameter to 1" (25 mm) |
standpipe | diameter standpipe adapter, Part |
| Number 3363920 |
|
|
Overhead sewer | Standard 20 gal. (76 L) 34" (864 mm) |
future reference.
Tools needed:
#2 Phillips and
Adjustable wrench that opens to 1" (25 mm) or 9⁄16"
Wire stripper (direct wire installations)
¼" nut driver or socket wrench (recommended)
Tin snips (for new vent installations)
Caulking gun and compound (for installing new exhaust vent)
Level
Knife
Vent clamps Pliers Scissors
Wood block (for leveling) Ruler or measuring tape
| tall drain tub or utility sink and sump |
| pump (available from local plumbing |
| suppliers) |
|
|
Floor drain | Siphon break, Part Number 285320, |
| additional drain hose, Part Number |
| 285702 and connector kit, |
| Part Number 285442 |
|
|
Drain hose too short | Drain hose, Part Number 285664 and |
| connector kit, Part Number 285442 |
|
|
Lint clogged drain | Drain protector, Part Number 367031 |
|
|
Water faucets | 2 longer water fill hoses: |
beyond reach of fill | 6 ft (1.8 m) Part Number 76314, |
hoses | 10 ft (3.0 m) Part Number 350008 |
Parts supplied:
Remove parts package from the washer basket. Check that all parts were included.
A | B | C | D | E |
A. Rear leveling legs (2) |
| D. Plastic strap |
| |
B. Front leveling legs (2) |
| E. Silver | ||
C. Drain hose |
|
|
|
|
Parts needed:
Check local codes. Check existing electrical supply and venting, and see “Electrical Requirements” and “Venting Requirements” before purchasing parts.
Mobile home installations require metal exhaust system hardware available for purchase from the dealer from whom you purchased your washer/dryer. For further information, please reference the “Assistance or Service” section of the Washer/Dryer User Instructions.
LocationRequirements
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from dryer.
Failure to do so can result in death, explosion, or fire.
You will need
A location that allows for proper exhaust installation. See “Venting Requirements.”
A separate
If you are using a power supply cord, a grounded electrical outlet located within 2 ft (610 mm) of either side of the washer/ dryer. See “Electrical Requirements.”
A sturdy floor to support the washer/dryer weight (washer/ dryer, water and load) of 500 lbs (226.8 kg).
2