LG Electronics WD(M)-10131F, WD(M)-80130F, WD(M)-65130F, WD(M)-10130(5)F Pump, Heater, Thermistor

Page 31

PUMP

Pump Outlet Hose

Screw

Cap

 

(Remaining Hose)

Tub Pump Bellows

Remove pump outlet hose.

Remove tub pump bellows.

Remove cap (Remaining Hose.)

Disconnect the wiring.

Unscrew 2 screws. Remove the pump.

HEATER

Loosen the M6 heater nut to pull out the heater.

CAUTION

When mounting the heater, be sure to insert the heater into the heater clip on the bottom of the tub.

THERMISTOR

Pull it out by holding the thermistor bracket.

If it is pulled by the wire, it may be broken.

When mounting the thermistor again, make sure that it is got back tight to the bushing.

31

Image 31
Contents Washing Machine Contents WDM-65130F, WDM-80130F, WDM-101301, 5F SpecificationFeatures Features & Technical ExplanationWater Level Control Determine Washing Time by Fuzzy LogicDoor can not be Opened Parts Identification AccessoriesBolts InstallationHOW to Connect Inlet Hose Test Operation Wash program selector OperationTemp. Option Spin Wash program selector Temp. Option Spin Wiring Diagram / Program Chart Before Performing Service TroubleshootingQC Test Mode Error Symptom Error DisplayDiagnosis and Answer for Abnormal Operation Error Diagnosis and Check ListDoor Open Error Clean the compartment for softener No Power Fault Diagnosis and TroubleshootingDetergent does not Flow No Water SupplyAbnormal Sound Softener does not FlowDrain Malfunctioning Heating Without WaterWash Heater Trouble Heating Continuously Above Setting Water TemperatureSpin Trouble Control Panel Disassembly InstructionsDispenser Assembly Lower Cover Door Inlet ValveGasket Assembly Damper Hinge PULLEY, MOTOR, DamperHeater PumpThermistor When Foreign Material is Stuck Between Drum and TUB Switch ASSEMBLY, Door LockExploded View Exploded View of Cabinet AssemblyExploded View of Control Panel & Dispenser Assembly Exploded View of Drum & TUB Assembly No.3828ER3013A